PERFORM GFCI TEST

Note: GFCI test applies to North America only. This feature is not available on CE rated systems.

Follow these steps to perform a GFCI test:

1 – Press the Settings button on the Main screen.

2 – Press the Diagnostics button on the
Settings screen

3 – Press the GFCI Test button (C) on the
Diagnostics screen. The GFCI Test screen will appear

If the GFCI Test status is “Passed” (F), you may not need
to perform this test

If the GFCI Test status is “Armed” (D), proceed to the next step.

4 – Press the Test button (E). Within approximately 12 seconds, one of the following two things will happen:

1 – The spa powers Off. After the spa powers Off, go to the GFCI and power On the spa. When the spa is powered On, it goes into Priming Mode. When Priming Mode is complete, navigate to the GFCI Test screen and confirm that it says “GFCI Status – Passed” (F).

2 – A “GFCI Test Failed” message appears. In this case, contact a qualified service technician. While you wait for the spa technician to arrive, the spa can be run normally for a time by cycling the power.

Reset Button: Only use the Reset Button prior to moving the spa to
a new location. Pressing the Reset the button forces a
new Test to be performed at the new location.